It is also the most difficult question to answer; there are no rules established to determine the answer.
A lot of attention must go to this stage.
We start by interviewing and examination.
What is the best simulation for a particular field situation?
|
It is also the most difficult question to answer; there are no rules established to determine the answer.
|
Typical questions:
Why do you need
tribological information: for development, quality
control, failure issue, marketing support…
What specific information
is needed: wear rate, friction
force, temperature increase, surface degradation,
fluid
degradation,…?
How will it be possible to
confirm correlation: references or field
experience available?
This stage requires a very direct communication. We visit on-site to discuss the project or we invite you to our lab for discussion on test equipment.